Unlike the barbed fitting, where the tube just goes over it, the locking ring big and visible part of the compression fitting, leaving a lot of room for manufacturers to play around with the aesthetics. There is a point where the locking ring compresses and grips the tube, making an airtight seal, hence the name „compression fitting“. The other part is the locking ring which screws on to the base of the fitting and it prevents the tubing from slipping off the barb. As for the old-school barb fittings, there is only one number present, the OD of the barb, which has to match with the ID of the tubing that will be used. Thankfully, both the tubing and fitting types are standardized, so you are able to choose from 10/13, 10/16, and 12/16 sizes of soft tubing compression fittings.Ī soft tubing compression fitting ( STC) consists of two parts, the main part is the base and it’s very similar to the standard barb fitting, but it has an additional thread. Both these number markings of the tubing must match with the fitting. These compression fittings are marked with two numbers that state the inner diameter (ID) and outer diameter (OD) of the tubing that is compatible with the fitting. The compression fittings themselves are divide into two major categories which are, Soft Tubing Compression and Hard Tubing Compression fittings, or for short STC and HDC. While barb fittings are still available for workstation purposes and applications where the aesthetics are not a key point, the market is dominated by compression type fittings. While in the early days we had simple barb fittings, nowadays the market has narrowed down to only compression type fittings. The tubes you use must exactly match the ID and OD parameters of the fitting you are using, because if leaks occur, your components may be harmed. Water cooling components like fittings and tubing are best not bought from the flea market. The most important thing is to pick parts from well-known manufacturers to avoid incompatibilities and unpleasant experiences with water cooling just because someone wanted to save a few bucks on the tubes on fittings. There might be some other tubing and fitting sizes available on the market, but we will not cover all of them. Since the imperial way of marking the fittings is getting less and less popular these days, its really easy to differentiate the fittings by using just 12, 14, and 16 as the size differentiators. Some fittings on the market use only a number to mark the size without using the unit next to it. These three most common tubes are marked with numbers such as: There are two ways to mark the fittings, one is using metric millimeters (mm) and the other is using imperial inches (“). Tubes are marked with ID and OD which stand for „Inner Diameter“ and „Outer Diameter“. The liquid cooling market provides three diameters of soft tubing that are the most common. Metric and imperial measurements of the fittings provide inner and outer diameter. How to read tube and fitting measurements? It’s important that you know all the possible choices of fittings because they can have a big visual impact on the finished build. First, you must decide what do you prefer because there are several sizes and types of fittings and tubing which make this subject quite broad.
TUBE BENDING INSTRUCTIONS CHART PC
0 kommentar(er)
